markb
all messages by user
12/17/2017
Topic:
Freeblox UI install error
markb
|
Hi All, I've been wrestling with this problem ..interfaces config just disappearing when freeblox rpm is installed. Doing ifconfig eth0 and giving it an IP/mask allows me to get to the GUI but the interfaces were not appearing in network status. Updating blox didn't resolve the problem. After a lot of trial and error I've got a solution.
Firstly if you're building this VM in hyper-V you must install "legacy network adapters" NICs in my case I setup three, after the initialize they appear as eth0,eth1 and eth2.
I made a backup of ifcfg-ethX files then copied them back
mkdir /etc/sysconfig/network-scripts/backup cp /etc/sysconfig/network-scripts/ifcfg-eth0 /etc/sysconfig/network-scripts/backup/ifcfg-eth0
cp /etc/sysconfig/network-scripts/backup/ifcfg-eth0 /etc/sysconfig/network-scripts/ifcfg-eth0
Now I refresh network status and the ethX NICs are there. Thanks, MB |