Get help with installing and configuring Blox SBC
Getting Started
munozj Posts: 2
3/6/2015
|
So i followed the instructions on the Quick Install Guide, http://www.blox.org/DownloadInstall, and was able to install Blox and get IP's configured for both cards. What's the next stop after setting the IPs? How do we proceed to configure the system?
The getting started page indicates (http://www.blox.org/getstarted) that there are two files to download. I registered but but the only downloads appearing on the download page are the Blox ISO and the Quick Install PDF. Apparently there is a separate GUI that has to be added but I can't see where to get that. edited by munozj on 3/7/2015
|
|
0
link
|
munozj Posts: 2
3/9/2015
|
Just noticed on the download page of the website: InstructionsDownload the BLOX iso file from the below download link & install it.Contact support@blox.org for Freeblox user interface RPM file.Download the Freeblox RPM file & install in the BLOX SBC system.Please follow the instruction from the installation guide. Not sure how I missed that before.
|
|
+1
link
|
rohan Administrator Posts: 8
3/11/2015
|
rohanAdministrator Posts: 8
Hello Munozj,
The SBC features can be configure through Freeblox WebGUI. The Freeblox GUI is a Freeware not the open source! Please contact enquiry@blox.org & avail the download link.
|
|
0
link
|
SiSrivas Posts: 1
5/24/2017
|
What are minimum Spec and Hardware Requirements, Computer OS requirements and SBC software for a trial SBC setup?
|
|
0
link
|
bloxsupport1 Posts: 232
5/28/2017
|
SiSrivas wrote:
What are minimum Spec and Hardware Requirements, Computer OS requirements and SBC software for a trial SBC setup?
Minimal System Requirement
- CPU 64 bit support
- 2GB RAM
- 2 Ethernet port (WAN/LAN)
|
|
0
link
|