blox

   
Dalton
Dalton
Posts: 2


6/13/2016
Dalton
Dalton
Posts: 2
Hi There

I am looking at using Blox as a viable SBC solution, however, my requirements are as follows:

1) Perform Upper Registrations whereby the SIP headers are rewritten when passed on to the back end PABX. (Not an additional Via header)
2) It needs to keep an entry of which endpoints are registered on the multiple back end PABXs and which are not.
3) It needs to allow for RTP pass through whereby the RTP header will be rewritten in the SBC to use itself as an RTP Proxy.
4) It needs to be able to trans-code where necessary.
5) It needs to be able to talk to the back end PABXs on separate internal interfaces while accepting public traffic on the external interface.
6) It needs to be able to determine which PABX to send the call/registration to depending on the domain used.

Are these options all possible with Blox or OpenSIPs?

Thanks a lot for your time.
edited by Dalton on 6/13/2016
0 link
varadhan
varadhan
Administrator
Posts: 68


6/13/2016
varadhan
varadhan
Administrator
Posts: 68
Hello Dalton,

Blox Supports above mentioned expect below cases
1. Upper Registration is possible only via Transaction it would be adding the Via header on the Request towards internal PBX, but it still hides the internal topology information from Via Header on the response towards the client.
4) It needs to be able to trans-code where necessary. - to do this you need allo transcoding card.
6. Domain based routing will be available soon in the next release.

Thanks
edited by varadhan on 6/13/2016
0 link
Dalton
Dalton
Posts: 2


6/13/2016
Dalton
Dalton
Posts: 2
Awesome. Thanks for the prompt response Varadhan.
edited by Dalton on 6/13/2016
0 link
mhasanbd
mhasanbd
Posts: 2


6/14/2016
mhasanbd
mhasanbd
Posts: 2
Having problem with configuring Trunk.
I've two asterisk call server and want to use Blox at border of those two. I've gone through the Blox manual, but the trunk among Blox, Internal Server and External server is not working. need immediate help. Is there anyone up here? please!!!
0 link
varadhan
varadhan
Administrator
Posts: 68


6/14/2016
varadhan
varadhan
Administrator
Posts: 68
mhasanbd wrote:
Having problem with configuring Trunk.
I've two asterisk call server and want to use Blox at border of those two. I've gone through the Blox manual, but the trunk among Blox, Internal Server and External server is not working. need immediate help. Is there anyone up here? please!!!


Hello,
We might need to understand the issue and configurtion you have made so far. Please contact for online support: blox.support
and send your screenshot to support@blox.org
0 link
Girish
Girish
Posts: 15


8/6/2017
Girish
Girish
Posts: 15
RTP pass through whereby the RTP header will be rewritten in the SBC to use itself as an RTP Proxy. -- any one has tried this ? Can please advise how to do it ?
0 link
bloxsupport1
bloxsupport1
Posts: 120


8/18/2017
bloxsupport1
bloxsupport1
Posts: 120
We use rtpengine, currently the behavior is same as you mentioned, kindly update to the latest version and try.

Girish wrote:
RTP pass through whereby the RTP header will be rewritten in the SBC to use itself as an RTP Proxy. -- any one has tried this ? Can please advise how to do it ?
0 link
Tonyb
Tonyb
Posts: 4


8/26/2017
Tonyb
Tonyb
Posts: 4
I an considering using blox but i have a requirement.
1. I have a inbound leg from a Asterisk running A2billing SIP it is sending to
2. a outbound GSM Voice gateway using SIP in the call setup it gets a voice message the carrier saying "the SIM is out of money"
3. We want to route he call to another Voice Gateway using the same dialed number and connect the call for the caller.

Can Blox do this. The call is all g711 no codec transcoding.
0 link
bloxsupport1
bloxsupport1
Posts: 120


8/27/2017
bloxsupport1
bloxsupport1
Posts: 120
Can we get the packet capture for the response "SIM is out of money" so that we can analysis the trace and inform you.
Blox wont check the voice packet response from the GSM gateway carrier, so if there is any negative reply in signalling it can be manipulated.

Tonyb wrote:
I an considering using blox but i have a requirement.
1. I have a inbound leg from a Asterisk running A2billing SIP it is sending to
2. a outbound GSM Voice gateway using SIP in the call setup it gets a voice message the carrier saying "the SIM is out of money"
3. We want to route he call to another Voice Gateway using the same dialed number and connect the call for the caller.

Can Blox do this. The call is all g711 no codec transcoding.

edited by bloxsupport1 on 8/27/2017
0 link
Tonyb
Tonyb
Posts: 4


9/10/2017
Tonyb
Tonyb
Posts: 4
Tonyb wrote:
I an considering using blox but i have a requirement.
1. I have a inbound leg from a Asterisk running A2billing SIP it is sending to
2. a outbound GSM Voice gateway using SIP in the call setup it gets a voice message the carrier saying "the SIM is out of money"
3. We want to route he call to another Voice Gateway using the same dialed number and connect the call for the caller.

Can Blox do this. The call is all g711 no codec transcoding.
0 link
Tonyb
Tonyb
Posts: 4


9/10/2017
Tonyb
Tonyb
Posts: 4
This file includes the regular setup and the error serup with the rtp.
0 link
bloxsupport1
bloxsupport1
Posts: 120


9/10/2017
bloxsupport1
bloxsupport1
Posts: 120
we couldn't get the file, please mail us to support@blox.org or share the uploaded link (gdrive, dropbox) ?
0 link
Tonyb
Tonyb
Posts: 4


9/14/2017
Tonyb
Tonyb
Posts: 4
bloxsupport1 wrote:
we couldn't get the file, please mail us to support@blox.org or share the uploaded link (gdrive, dropbox) ?

I emailed the file.
0 link
bloxsupport1
bloxsupport1
Posts: 120


9/17/2017
bloxsupport1
bloxsupport1
Posts: 120
we have not received any email from you.


Tonyb wrote:
bloxsupport1 wrote:
we couldn't get the file, please mail us to support@blox.org or share the uploaded link (gdrive, dropbox) ?

I emailed the file.
0 link






Powered by blox.org 1.0.0.0 © 2015