Get help with installing and configuring Blox SBC
IP Authentication
txgeek247 Posts: 1
8/12/2015
|
I just installed Blox on dedicated hardware and have everything configured with the exception of the Trunk configuration.
My ITSP uses IP based authentication, so there is no username/password. How do I go about setting up the trunk when those fields are required?
Thanks
|
|
0
link
|
varadhan Administrator Posts: 69
8/12/2015
|
Hello,
1. We have made the changes for this REGISTRAR as optional, which will get it resolved in the next release. (before this month end)
2. Temporarily, you can manually remove with following commands
$ mysql -u opensips opensips_1_11 --password=opensipsrw -e 'delete from registrant'; $ /etc/init.d/opensips restart
These changes might get overwritten (reappear), once you make changes in GUI and do apply changes so again you need to run both the commands, this is temporary solution for you to proceed.
Thanks
|
|
0
link
|
smartarray Posts: 1
9/9/2015
|
Hi,
I have installed the latest version however the GUI still requires me to add a username and password to create the SIP trunk to my provider.
Was this updated so that IP Auth could be used? v0.9.9 Installed.
Thanks Neil
|
|
0
link
|
varadhan Administrator Posts: 69
9/10/2015
|
You can ignore the REGISTRAR part to avoid REGISTRATION, also specify the dummy username/password just to avoid validation issue. It will not be used unless there is a challenge for authentication.
|
|
0
link
|