SBC
Firewall Rules for RTP Engine
Girish Posts: 20
8/19/2017
|
Hello Support,
I face this issue where once the service is restarted I can see the below lines in the firewall opening the RTP engine and ports.
Chain rtpengine (1 references) pkts bytes target prot opt in out source destination 0 0 RTPENGINE udp -- * * 0.0.0.0/0 0.0.0.0/0 RTPENGINE id:0 0 0 ACCEPT udp -- * * 0.0.0.0/0 0.0.0.0/0 udp dpts:16000:20001
Once I make any changes on the Geo IP Filter like say I remove a country (block a country from the list) and click apply changes then) the firewall rules of RTP engine disappears until I go and change the port under Media from 20001 to say 20002 and apply changes the Rules chain is back.
Please help. edited by Girish on 8/19/2017
|
|
0
link
|