blox

   

Home Session Border Controller -General

SBC

Firewall Rules for RTP Engine Messages in this topic - RSS

Girish
Girish
Posts: 20


8/19/2017
Girish
Girish
Posts: 20
Hello Support,

I face this issue where once the service is restarted I can see the below lines in the firewall opening the RTP engine and ports.


Chain rtpengine (1 references)
pkts bytes target prot opt in out source destination
0 0 RTPENGINE udp -- * * 0.0.0.0/0 0.0.0.0/0 RTPENGINE id:0
0 0 ACCEPT udp -- * * 0.0.0.0/0 0.0.0.0/0 udp dpts:16000:20001


Once I make any changes on the Geo IP Filter like say I remove a country (block a country from the list) and click apply changes then) the firewall rules of RTP engine disappears until I go and change the port under Media from 20001 to say 20002 and apply changes the Rules chain is back.

Please help.
edited by Girish on 8/19/2017
0 link
bloxsupport1
bloxsupport1
Posts: 232


8/21/2017
bloxsupport1
bloxsupport1
Posts: 232
No need to change the port number again you can run the command "service rtpengine restart"
currently you can do as a workaround, will fix it in next update

Girish wrote:
Hello Support,

I face this issue where once the service is restarted I can see the below lines in the firewall opening the RTP engine and ports.


Chain rtpengine (1 references)
pkts bytes target prot opt in out source destination
0 0 RTPENGINE udp -- * * 0.0.0.0/0 0.0.0.0/0 RTPENGINE id:0
0 0 ACCEPT udp -- * * 0.0.0.0/0 0.0.0.0/0 udp dpts:16000:20001


Once I make any changes on the Geo IP Filter like say I remove a country (block a country from the list) and click apply changes then) the firewall rules of RTP engine disappears until I go and change the port under Media from 20001 to say 20002 and apply changes the Rules chain is back.

Please help.
edited by Girish on 8/19/2017

edited by bloxsupport1 on 8/21/2017
0 link






Powered by blox.org 1.0.0.0 © 2015